Alarm Lock Trilogy DL3500 Manuel d'instructions télécharger pdf (Page 7)

Lock Operation

Important: Before attempting to program any codes or

functions, Note the following:

• While the lever or knob may be rotated at any time, the latch

will not be engaged to unlock the door unless a valid code has

been entered.

• When a valid code is entered, the lock will unlock immediately

and remain unlocked for about 3 seconds (or longer, if

reprogrammed by functions 53 and 54).

Programming - Notes

It is recommended that all programming be prepared in advance

using the DL3500 Programming Sheets for reference while

programming (see User Code and Schedule Recording sheets

at the back of this manual), then be secured when finished.

PROGRAM LEVELS

You must have the programming authority level equal to the

authority level required to access a programming function.

Programming authority levels can have a value of 1, 2, 3, 4 or M.

A programming authority level of M (Master) is associated with

the Master Code and cannot be associated with any other user.

CODE TYPES

Program level ability is fixed according to table on page 11. The

codes are defaulted to the tabulated group associations when

adding codes using Program Function 2.

Master Code - User 1: Always enabled and can program all

functions, can't be group associated.

Installer Codes - Users 2 & 3: Allow all functions except

master code change.

Manager Codes - Users 4 - 6: Can program all functions

except functions relating to lock configuration, no default group

association.

Supervisors - User 7 - 9: Can only program functions relating

to day to day operation, no default group association.

Print Only Codes - Users 10 & 11: Allow access to print audit

trail only.

Basic User Codes: No program ability, default group

association.

Program Level Required - The

program level required to access

the Function. Possible

Programming Levels of 1,2,3,4 and

M, where M = Master Code.

Program Authority Level of User

must be equal to the Function that

is to be accessed.

3. Disable User

; 3 ; [ _ _ _ ] :

4. Enable User

; 4 ; [ _ _ _ ] :

• User Number must be between 2 and 300.

NOTE: Will Enable/Disable users even if the user is associated with a enabled group.

Enabling/Disabling Users (By User Number)

Programming key sequence.

Function Name

Programming

Information

If a wrong key is pressed during code entry, hold any key continuously until the error sound is heard (7 short beeps),

this will clear the entry, then re-enter the key sequence again.

General Program Mode Information

Visible LED and Audible Sounder Indicators

Normal Battery

Activity LED SOUNDER

Keypress 1 RED Flash 1 Beep

Enter Valid Enabled Code 3 GRN Flashes 3 Beeps

Enter Invalid No/Wrong Code 6 RED Flashes 6 Beeps

Successful Program Entry 2 GRN Flashes 2 Beeps

Unsuccessful Program Entry 7 RED Flashes 7 Beeps

Low Battery is indicated by a Yellow Flash during Key Press and a Long Beep.

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Alarm Lock Trilogy DL3500 Manuel d'instructions Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Alarm Lock Trilogy DL3500