Alarm Lock Trilogy PL3000 Manuel d'instructions télécharger pdf (Page 17)

Function Card #2 (cont'd)

IMPORTANT NOTE:

When programming is sent from DL-Windows (or an AL-DTM) to the lock, Function Cards 1, 2, 8, and 9 will be overwritten

with the existing data in DL-Windows for the User Locations 298, 299, 297 and 300, respectively. Therefore, to continue to

use Function Cards 1, 2, 8 and 9 that were enrolled at startup with DL-Windows, be sure to enroll those same Function

Cards 1, 2, 8 and 9 used at startup into the correct locations within DL-Windows. For complete instructions, see the

DL-Windows User Guide, OI237.

RECEIVE PROGRAM FROM THE LOCK TO THE AL-DTM

DL-Windows must be first used to instruct the AL-DTM to "Receive Program From Lock" via the DTM Support screen.

This way, when the AL-DTM is connected to the PL3000 lock, the AL-DTM will perform the correct operation.

1. Connect the AL-DTM to the Lock. Connect the double-ended banana plug into the AL-DTM and into the lock

that is to be programmed (observing proper tab direction).

2. Press the Green Button on the AL-DTM until the AL-DTM displays the following:

The AL-DTM displays the following:

3. Present Function Card #2 to the lock. The AL-DTM will display the following:

Packet Numbers will go up until all packets have been transferred to the AL-DTM. The Lock will continue to beep

while in communication with the AL-DTM.

4. At the end of the transfer process, the PL3000 will sound a series of beeps. You can disconnect the AL-PCI2

cable. The following will display:

LOCK MODE

YES NO

Door 08, Receiving

PGM Packet 008

Lock's Time and

Date, Updated.

Comm. Complete,

07/24/04 02:28PM

(Current date and Time)

0993 FREE

MEMORY BLOCKS

(Current Memory Status)

Press the left black button (answer YES).

Waiting for Lock

Power Up or Code

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Pas de commentaire

Alarm Lock Trilogy PL3000 Manuel d'instructions Page 17